Ultra high temperature sterilization machine

First, UHT instant sterilization machine introduction:
​This equipment is suitable for the instantaneous sterilization of fresh milk, juice, beverage, Popsicle, ice cream pulp, condensed milk, soy sauce, vinegar, soy milk, wine and other liquid materials, and can also be used for the sterilization of fluid medicine, the effect is very significant. The feed and discharge of the equipment are using three-way cock, flow can be adjusted according to need, reliable use.
​Two, UHT instant sterilization machine functions and characteristics:
​The equipment and the material contact part, all made of stainless steel 0Cr18Ni9, double sets of disk pipe special machine tool processing, the inner surface is smooth, so that liquid material through the double sets of coil to form a uniform liquid layer, heating is very uniform.
​Equipment features:
​Continuous production, sterilization time is very short.
​High quality products due to short heating time.
​Due to the use of ultra-high temperature sterilization, the sterilization effect is particularly good. Use in series with centrifugal pump or high pressure homogenizer, a wide range of applications, suitable for sterilization of high viscosity materials 5, because the design of the heat exchanger with hot and cold materials has the economic effect of waste heat utilization, so the steam consumption is small.
​Three, UHT instantaneous sterilization machine working principle:
​The general material is pumped into the sterilization machine by the centrifugal pump into the hot and cold material heat exchange device to be preheated, and then through the high temperature bucket full of high pressure, the material is rapidly heated to the sterilization temperature and maintained for about 3 seconds before and after, in which the microorganisms and enzymes are quickly killed. After the material is discharged from the high-temperature barrel, it is cooled by heat exchange with the cold material, and the general temperature is lower than 65C. If the temperature needs to be increased in the next process, the requirements can be met by adjusting the Angle type stop valve or circulation, and otherwise the discharge temperature can be reduced by accessing the cooling water. The discharge is controlled by a throttle valve, which can make the boiling point of the material higher than the maximum temperature under a certain pressure. The valve is adjusted during normal production, and the back pressure control flow is generated by the driving force of the pump to overcome the projectile and arrow pressure. It should be fully opened when cleaning and sterilizing the machine. The circulating storage tank can be used to prepare acid-base solution to effectively clean the inner wall of the coil. Due to the simultaneous use of stainless steel three-way cock, the flow rate can be properly regulated.